Skip to content

Collection: ABAC Ironman Air Compressors

ABAC Ironman Air Compressors

The Ironman range is ABAC's cast iron answer to continuous shop duty. Every machine on this page runs a fully cast iron two-stage pump at 175 PSI, in either the C1 or the larger C2 build, on an ASME receiver. Cast iron cylinders shed heat better than aluminium or hybrid pumps and tolerate the long duty cycles that a working shop imposes, which is most of the reason these machines weigh what they do.

The simplex machines cover 5, 7.5 and 10 HP on 80 and 120 gallon tanks, vertical or horizontal, with Full Feature builds that add a magnetic starter and an automatic tank drain. The duplex machines pair two pumps and two motors on one 120 or 200 gallon receiver for 10, 15 and 20 HP of alternating or simultaneous output, so a single unit can idle one pump through a quiet shift and bring both online when demand spikes. The gas drive machines put the same cast iron pump behind an 11 to 16 HP Honda, Kohler or Vanguard engine on a 30 gallon horizontal tank for job sites with no power at the wall.

Comparing against the lighter end of the range? The ABAC Hybrid Pro machines use a mixed aluminium and cast iron pump and cost less to buy and to lift. See the whole brand in ABAC air compressors, the wider piston air compressors range, or step across to rotary screw air compressors if the shop runs air all day. Pair any of these with an ABAC COOL refrigerated dryer to keep water out of the lines.