Skip to content

Collection: 213-215 Frame Electric Compressor Motors

213 - 215 Frame Electric Compressor Motors

213T and 215T frame electric compressor motors for larger 7.5 HP and 10 HP compressors.

NEMA frame numbers describe the physical mounting of the motor, not its power. A 213T and a 215T share the same shaft height and bolt spacing across the base, and differ in the distance between the front and rear mounting holes, which is what the third digit changes. Getting the frame right is what lets a replacement motor drop onto the existing rails and line up with the sheave without you fabricating anything.

The T suffix matters just as much. T frame motors use the modern shaft diameters and keyseat dimensions, so a T frame motor will not accept a sheave or coupling made for an older U frame of the same number. If the motor you are pulling off is decades old, measure the shaft before assuming the new sheave will fit.

When ordering, match frame, horsepower, voltage, phase, speed and shaft diameter to the nameplate on the unit you are replacing, and make sure your motor starter and overload are rated for the new full load amps. For smaller machines see our 5 to 7.5 HP compressor motors and 56 frame motors. Send us the nameplate photo and we will confirm the fit before you order.