Skip to content

Collection: ABAC Duplex Air Compressors

A duplex air compressor puts two complete motor and pump assemblies on a single receiver. The controller alternates between them so the running hours stay even, and it can bring both online together when demand spikes. The reason shops buy one is redundancy: a pump or a motor can be pulled for service while the other side keeps the air up, and nobody goes home early.

What is in this range

ABAC builds its duplex machines on 120 and 200 gallon horizontal ASME tanks, from 10 to 20 HP of combined power, delivering 32 to 64 CFM at a maximum 175 PSI. There are two pump families to choose between:

  • Hybrid Pro duplex: two T39 two-stage pumps that pair an aluminum block with cast iron cylinders. Lighter and less expensive at the same horsepower, and the right call where the air draw is intermittent.
  • Ironman duplex: two fully cast iron C1 or C2 two-stage pumps. Heavier, and built for the long duty cycles that a busy shop or a production line imposes.

Sizing one

Add up the CFM the tools actually draw at the same time, then add about 30 percent of headroom. A duplex is not primarily a way to buy more airflow, because a single machine of the same total horsepower usually costs less. It is a way to buy uptime. If a day without air costs more than the price difference, buy the duplex. If it does not, a simplex on a large tank is the better value, and the Ironman and Hybrid Pro ranges cover the same horsepower in single pump builds.

Check the panel before ordering: these machines run on 230V single phase at the smaller end and 230V, 460V or 575V three phase as the horsepower climbs, and the voltage is set at build. Pair any of them with a refrigerated dryer from the ABAC COOL range if the air goes to paint, tires or plasma cutting. See the full brand in ABAC air compressors. ABAC is part of the Atlas Copco group.