Some filters could not be applied and were reset.
-
Sale ABAC AB5-2180VP 5 HP Two-Stage Air Compressor - 80 Gallon Vertical, 175 PSI, 16.6 CFM T39 Pump with Magnetic Starter $2,962.00 Regular price $3,703.00Add to cart -
Sale ABAC AB5-2180V4 5 HP Two-Stage Air Compressor - 80 Gallon Vertical, 175 PSI, 14.6 CFM, 230V with Magnetic Starter $2,493.00 Regular price $3,116.00 -
Sale ABAC AB5-2180V4NS 5 HP Two-Stage Air Compressor - 80 Gallon Vertical, 175 PSI, 14.6 CFM, 230V Single-Phase $2,113.00 Regular price $2,642.00 -
Sale 6.0 HP, 80 Gal, Ultra Quiet Oil-Free Air Compressor - California Air | CAT-80060C $2,899.00 Regular price $3,624.00
80 gallon air compressors: the standard shop size
An 80 gallon tank is the size most working shops land on. It stores enough air that a 5 or 7.5 HP two stage pump is not cycling every minute, it still moves on a pallet jack through a standard door, and a 175 PSI rating packs more usable air into the same tank than a 125 PSI machine. Almost everything on this page is a two stage piston compressor rated 14.6 to 26 CFM, which covers one to three working bays.
What is on this page
ABAC makes up most of the selection in three families. The AB5 and AB7 Hybrid Pro range runs the T39 and PAT 49 pumps at 14.6 to 22.3 CFM in vertical and horizontal builds, with Premium full feature versions that add an aftercooler and an automatic tank drain. The ABC5 and ABC7 Ironman range uses the fully cast iron C1 and C2 pumps at 16 to 24 CFM. The AB5-2180VQP and AB7-2180VQP Quiet Power units put the same output inside a sound enclosure at 66 and 69 dBA. Alongside them are AirComParts Kellogg equivalent machines built on the 335, 452, Z332 and EC5 pumps, and the California Air Tools CAT-80060C, a 6.0 HP oil free ultra quiet unit for shops that cannot run an oil lubricated pump.
Vertical or horizontal
Same 80 gallons either way. A vertical tank puts the reserve on a small footprint and suits a shop with ceiling height but little open floor. A horizontal tank sits low enough to go under a mezzanine or a low ceiling and is easier to move on a pallet jack. Pick on the space you have, not on output, because the pump and motor are the same on both builds.
Power and installation
5 and 7.5 HP are the practical ceiling for single phase. Plan on a dedicated 230 volt circuit sized to the motor nameplate with a magnetic starter, or take three phase where the panel has it, since a three phase motor starts easier and runs cooler on a compressor that cycles all day. Bolt the tank down on isolation pads, leave clearance around the flywheel and belt guard for cooling air, and pipe the discharge with a flexible connector so vibration does not load the shop header.
Dryer sizing
Air leaves any piston compressor hot and saturated. Pair a 16 CFM machine with a 25 CFM refrigerated air dryer and a 22 to 26 CFM machine with a 30 to 35 CFM dryer, then go up a size if the compressor sits in a hot mechanical room, because dryer capacity falls as inlet temperature rises.



