Skip to content

Collection: ABAC Portable Air Compressors

ABAC builds portable air compressors at both ends of the range: small oil-free units a single person carries up a ladder, and gas drive machines that live on a service truck and run blasting equipment all day. What they share is that none of them needs a dedicated 230V circuit and a permanent footprint in the shop.

Choosing by the work

  • Trim, finish and inflation: the 1.2 HP Rollcage and 1.5 HP Suitcase run on a standard 120V outlet, weigh 22 to 40 lbs, and are quiet enough for occupied rooms
  • Framing and general contracting: the 1 HP Power Force pancake at 175 PSI and the 2 HP Twin Force twin stack at 135 PSI carry enough stored air for a nail gun through a working day
  • Fixed but space-tight: the XPN Flex wall-mounted tankless unit with a built-in hose reel keeps the floor clear in a garage or detail bay
  • Remote and mobile work: the 11 to 16 HP Honda, Kohler and Vanguard gas drive machines on 30 gallon horizontal ASME tanks deliver 22 to 32 CFM at 175 PSI with no shore power at all

Sizing without guessing

Portable compressors are sized on CFM at the pressure the tool actually needs, not on tank gallons. A framing nailer draws air in short bursts and a small tank covers it, while a sandblaster or a 1 inch impact wrench draws continuously and needs the pump to keep up on its own. Check the tool's rated consumption at 90 PSI, add about 30 percent headroom, and work up from there. Tank volume only buys you time between cycles.

For a compressor that stays in one place, see the ABAC piston air compressors and the ABAC AS rotary screw range, or browse the full ABAC lineup.